Plugger's 2pc Carbon Fiber Shaft for the Minelab Equinox with Whites Arm Cuff
Please state for which model, the 600 or 800. 2-piece Carbon Fiber (glossy finish) Shaft for the new Minelab Equinox. This listing is just for the Upper & Middle Shafts and a Whites Arm Cuff (1-bolt), you still have to use your stock Equinox coil rod and of course the Control Head/Handle. Two of my Plugger Shaft Locks are included and there is absolutely no wobble. Double Snap Button on the extension joint too!
Shaft is drilled for both the Whites arm cuff (3 positions 1-1/2" apart) and there are also 3 positions (holes) for the stock arm cuff and handle, starting at 12.5" from the end of the upper shaft and spaced 1.5" apart (12.5", 14" & 15.5") There are 7 holes in the middle shaft for adjusting the stock coil rod spaced at 1-1/2" apart starting about 2" from lower end. Both shafts together weigh less than 6 ounces (actually 5.7oz) without arm and about 10.2oz with arm cuff. Assembled length is just over 36.
For packing purposes, both shafts are less than 21" long, however, it is also important to note that the stock coil rod is 24" long. Special requests are always welcome.I will build to your specs, usually at no additional cost. Please note: I cannot drill for the Plugger cuff and the stock cuff. See my other listing for a Plugger cuff. The item "Plugger's 2pc Carbon Fiber Shaft for the Minelab Equinox with Whites Arm Cuff" is in sale since Saturday, March 31, 2018.
This item is in the category "Consumer Electronics\Gadgets & Other Electronics\Metal Detector Accessories". The seller is "rods_by_plugger" and is located in Carlsbad, California. This item can be shipped to United States, Canada, United Kingdom, Germany, France, Australia, Russian federation.- Country of Manufacture: United States
- Model: Equinox
- Country/Region of Manufacture: United States
- Type: Carbon Fiber
- MPN: Does Not Apply
- Brand: Rods by Plugger