Plugger's 2 pc 40 Carbon Fiber Travel Shaft for Equinox with snap button holes

2pc piece Carbon Fiber (glossy finish) Shaft for the new Minelab Equinox. This listing is just for the Upper & Middle Shafts, you still have to use your stock Equinox coil rod, arm cuff and of course the Control Head/Handle.

Two of my Plugger Shaft Locks are included and there is absolutely no wobble. Shaft is drilled for the stock arm cuff 3-holes spaced 1" apart starting 1-7/8" from the end. There are also 3 positions (holes) for the handle, starting at 11" from the end of the upper shaft and spaced 1.5" apart (11", 12.5" & 14") There are 7 holes in the middle shaft for adjusting the stock coil rod spaced at 1-1/2" apart starting about 2 from lower end.

Both shafts together weigh less than 6 ounces (actually 5.7oz). Assembled length is just over 40. For packing purposes, both shafts are less than 21" long, however, it is also important to note that the stock coil rod is 24" long.

Detector & Coil are not included, shown for illustration only! Special requests are always welcome. I will build to your specs, usually at no additional cost. The item "Plugger's 2 pc 40 Carbon Fiber Travel Shaft for Equinox with snap button holes" is in sale since Friday, July 20, 2018. This item is in the category "Business & Industrial\Test, Measurement & Inspection\Test Meters & Detectors\Metal Detector Accessories". The seller is "rods_by_plugger" and is located in Carlsbad, California. This item can be shipped to United States, Canada, United Kingdom, Germany, France, Australia, Russian federation.

Country of Manufacture: United States
Model: Equinox
Country/Region of Manufacture: United States
Type: Carbon Fiber
MPN: Does Not Apply
Brand: Rods by Plugger